My schiada's of days long gone...

[2manymustangs]

Next, off to dunsmore...leak down was horrible....30- to 70%..
so we ran the valves,.. all too tight..did an oil change and added some marvel mistery oil.....the next leak down was single digits

listen to the video...history repetes it self...lol..and look at the numbers wrote on the vlave covers

What kind of cam/lifter is in the engine sir? Edit... I read your post closer...

[2FORCEFULL]

What kind of cam/lifter is in the engine sir? Edit... I read your post closer...

did you listen to what I said at 1:35? lol... as far as the cam, I'd have to ask billy dinsmore, he built the motor and then rebuilt about 25 yrs later..the leak down after valve adjust and marvel.. was single digits..

[2manymustangs]

did you listen to what I said at 1:35? lol... as far as the cam, I'd have to ask billy dinsmore, he built the motor and then rebuilt about 25 yrs later..the leak down after valve adjust and marvel.. was single digits..

I read closer and listened to your comment, thus the edit...

I was curious if it was a solid roller or hydraulic roller (in reference to the valve lash / rockers being too tight)... My assumption is a solid roller if the lash adjustment made such a dramatic difference...

[2FORCEFULL]

I read closer and listened to your comment, thus the edit...

I was curious if it was a solid roller or hydraulic roller (in reference to the valve lash / rockers being too tight)... My assumption is a solid roller if the lash adjustment made such a dramatic difference...

it was solid lifter

[2FORCEFULL]

I read closer and listened to your comment, thus the edit...

I was curious if it was a solid roller or hydraulic roller (in reference to the valve lash / rockers being too tight)... My assumption is a solid roller if the lash adjustment made such a dramatic difference...

did you hear the quote, the hallett is too big????lolhistory...

[2manymustangs]

did you hear the quote, the hallett is too big????lolhistory...

I missed that... Ya, now I get it... The 21 Raysoncraft GN 227 has your name all over it... <10

[jordy]

Then a few years later, I picked up this 21' RC from Lonnie Fluent. Fun boat, but only had a tandem axle trailer, so I don't know if it really counted as a Schiada. I will say that running upriver was a little unnerving with the fixed v-drive running gear. It didn't draft much, but without the ability to trim anything? Yeah, there was a pucker factor.

I threw the OT's on so I could run the valves after I swapped out rockers. Couldn't get the covers off with the Gil Marine manifolds on. Freaked some of the Schiada crew out with that pic.

[2manymustangs]

Very nice Jordy!

[2FORCEFULL]

Then a few years later, I picked up this 21' RC from Lonnie Fluent. Fun boat, but only had a tandem axle trailer, so I don't know if it really counted as a Schiada. I will say that running upriver was a little unnerving with the fixed v-drive running gear. It didn't draft much, but without the ability to trim anything? Yeah, there was a pucker factor.

I threw the OT's on so I could run the valves after I swapped out rockers. Couldn't get the covers off with the Gil Marine manifolds on. Freaked some of the Schiada crew out with that pic.

what was wrong with the cav plate???