Water Pickup

[ogshotgun]

cp performance part number Cavitation Plate Style -10 AN Water Pick-Up
410-301101

comes in many sizes

[WESTERNAERO]

cp performance part number Cavitation Plate Style -10 AN Water Pick-Up
410-301101

comes in many sizes

I'm doing -16's and I making them now, so no need for CP's number but thanks. 7.0" off center sounds a little too close to center for some reason. Just from looking at other boats, I was thinking around 12.0" off center. But I am curious if there is some standard to this? Something that figures in the diameter of the prop + the angle of the bottom + distance from the prop, sort of thing.

[Sharp shooter]

One of Mikey's rigging jobs.

[ogshotgun]

I'm doing -16's and I making them now, so no need for CP's number but thanks. 7.0" off center sounds a little too close to center for some reason. Just from looking at other boats, I was thinking around 12.0" off center. But I am curious if there is some standard to this? Something that figures in the diameter of the prop + the angle of the bottom + distance from the prop, sort of thing.

i knew you would make your own ... was giving you the part number because i didn't have picture of them .. i looked at several boats yesterday and all of them were different ..

[SnoC653]

If you're running sea strainers the dual setups posted look great. Finally got the location for moving mine under the boat and off the cav plates. I was told to put it on the blast plate, beside the strut and in front of the prop. This actually makes sense as there should be good flow there and I won't have to worry about the cav plates cracking again. My old plate has a crack across the pickup, through the turnbuckle pad, to the inside split of the plate. I'm thinking at speed the added twist from the pickup drag was just enough to get it to start cracking. Not sure what happens if a plate fails, and I don't want to find out either. So to the blast plate mine goes.

[WESTERNAERO]

What material were your plates made from?

[SnoC653]

What material were your plates made from?

The plates that were on it were Aluminum that mic'd at .209 (3/16th is what we think it was supposed to be). They had a doubler that was 3" wide of the same material. Just the plate cracked, the doubler is still fine.

[WESTERNAERO]

The plates that were on it were Aluminum that mic'd at .209 (3/16th is what we think it was supposed to be). They had a doubler that was 3" wide of the same material. Just the plate cracked, the doubler is still fine.

Yeah I assumed they were aluminum, do you know what type and condition they were?