Dimarco cruiser

[ogshotgun]

Okay, here you go. The drive end of the shaft to mate with the cam drive. Shaft is made from A-286, all diameters ended being .0007 total run-out. It has 2 large bearings in the center of the shaft with a .0003 press so they won't be too hard to get off if they ever need replacing. I gave it .005 clearance on the male to female fit of the drive end to allow for any misalignment when it all goes together.

very nice i can sleep now trying to figure out going from a 1 bolt cam to a three bolt.. piece of cake for you... very very nice job