Yeah, the MSD will go on the transom along with a fuel water seperator, and the fuel pump.

Made some what i consider to be major progress this weekend. The Rail kit is in, and the mounts are made! O0 O0 > > : :



I learned that i need to try and heat and bend the headers up a little more. As it is right now they clear the transom but are a little close for my comfort


Front plates, i had purchased some bitchin billet motor plates online hoping they would work. Unfortunately they were about 1.5" to short in the front so i had to make these. Not CNC'd or Plasma cut but i think i did well


This rear plate works, and i'm just being picky. But im going to re-make it to give me just a tad more clearance under the oil pan.


Its so small...