here i finished the body work on the fenders and primed them , i also built one bunk wrapped it in carpet used all stainless steel , carriage bolts, staples too
finished the other bunk today , bad weather not much else got done, mess got cleaned up for the rain tonight and also got the mount for the draw bar mounted today no draw bar yet waiting on paint also made this little cable for the draw bar pin , if you drop it , its right there!! no more lost pins
What are the spacers for? Is that the way it was or did you want the boat so sit higher?
since the bunks are longer than the flat part of the hull the bunks bend down in the midgle and once the weight is on them it sits nice and cozy front to rear
since the bunks are longer than the flat part of the hull the bunks bend down in the midgle and once the weight is on them it sits nice and cozy front to rear
or better explanation the bottom of the hull is kind of banana shaped so when the center almost touches the frame both ends are frim on the bottom of the hull right below the stringers, i had to move them a few inches to get them under the stringers where they should be
break in the weather got the bottom side of the fenders painted also mounted the draw bar pin retaining cable and put a pad where the draw bar sits when not attached
Bookmarks