April HOTBOAT.COM of the month 2013 phase II

[Sharp shooter]

What are the spacers for? Is that the way it was or did you want the boat so sit higher?

[ogshotgun]

What are the spacers for? Is that the way it was or did you want the boat so sit higher?

since the bunks are longer than the flat part of the hull the bunks bend down in the midgle and once the weight is on them it sits nice and cozy front to rear

[ogshotgun]

since the bunks are longer than the flat part of the hull the bunks bend down in the midgle and once the weight is on them it sits nice and cozy front to rear

or better explanation the bottom of the hull is kind of banana shaped so when the center almost touches the frame both ends are frim on the bottom of the hull right below the stringers, i had to move them a few inches to get them under the stringers where they should be

[GotHalos]

Looking good. Spray paint?

[ogshotgun]

Looking good. Spray paint?

mo its valspar low voc single stage shot out of a Iwata HVLP gun with a 1.3 mm tip and 35 pounds of air pressure in my back yard with calm winds lol

[ogshotgun]

break in the weather got the bottom side of the fenders painted also mounted the draw bar pin retaining cable and put a pad where the draw bar sits when not attached

[ogshotgun]

Its so hard to upload pictures here iam almost ready to give up on it third and last try i swear this is lameAttachment 32943Attachment 32944Attachment 32945Attachment 32946Attachment 32947Attachment 32948Attachment 32949

[ogshotgun]

Thats it three trys over a hour of wasted time trying to share sorry no more pictures of progress.