Chevelle Engine Swap

[Sharp shooter]

So I had the car tuned last Friday at Engine Dynamics. I still had a trans leak and a p/s belt alignment issue. We wnt to the grand canyon over the weekend so I just got back to the car yesterday and today and replaced a vacuum modulator O ring and adjusted the p/s belt alignment. All looked good so I went for a good long drive to check cooling, leaks, hot start etc. Knock on wood but so far so good.

The engine wants to rev much better than the old 396 and gassing 1st gear even from a roll it just lights the tires. 2nd gear pulls pretty good, but it might need a little more tweaking to get everything out of it. That being said, I think it's ready for a track day.

[chevellesb406]

So I had the car tuned last Friday at Engine Dynamics. I still had a trans leak and a p/s belt alignment issue. We wnt to the grand canyon over the weekend so I just got back to the car yesterday and today and replaced a vacuum modulator O ring and adjusted the p/s belt alignment. All looked good so I went for a good long drive to check cooling, leaks, hot start etc. Knock on wood but so far so good.

The engine wants to rev much better than the old 396 and gassing 1st gear even from a roll it just lights the tires. 2nd gear pulls pretty good, but it might need a little more tweaking to get everything out of it. That being said, I think it's ready for a track day.

Mickey Thompson drag radials sound like they are in your future. If we can make it on the same weekend, you are free to make a pass with mine, they will fit, I intentionally left the rear end in factory dimensions to take the mystery out of rim choice. 4.5" back spacing 275 x 60 x15 tuck up real nice, probably could go a little bigger on a custom rim.