Water Pickup

[ogshotgun]

Well they aren't 7075 then. I put ammonia and soaked the area between the turnbuckle pads and no black. The plates were painted black and you can see the doubler was also. Paint is worn off/polished off the doubler.

Here is a picture of the crack itself. You can see where it ran along the pressure line from the turnbuckle pad and then started heading to the front edge. This is the bottom of the plate.

i have seen this exact issue on a boat before in the exact spot...it was damaged from a floor jack lifting the back of the boat up to service the rudder... no need to re invent the wheel .. its metal its old worn out .. replace it.. if the tire on your car gets a slice do you replace the tire or re invent the wheel ???

also that looks like type III hard anodizing also ... fades bad in the sun will lose the color but not the coating and its i believe aout 2-3 thousands thick