Should have bought another Chevy. :(
Results 1 to 10 of 52
Thread: Found on Road Dead
-
03-17-2014, 02:32 PM #1Senior Member
- Join Date
- Oct 2012
- Location
- Costa Mesa, CA
- Posts
- 1,483
Found on Road Dead
-
03-17-2014, 02:33 PM #2Already miss the 310/562
- Join Date
- Sep 2013
- Location
- 314 ish....
- Posts
- 6,050
What broke?
-In a Republic, the sovereignty resides with the people themselves. In a Republic, the government is a servant of the people, and obliged to its owner, We the People..
"Remember, democracy never lasts long. It soon wastes, exhausts, and murders itself. There never was a democracy yet that did not commit suicide." John Adams
-
03-17-2014, 02:44 PM #3Senior Member
- Join Date
- Oct 2012
- Location
- Costa Mesa, CA
- Posts
- 1,483
While driving on the 40 last Thursday night the water temp gauge pegged hot, oil light came on and the truck went into limp mode. I pulled to the side of the road and the truck showed no signs over overheating. I turned the key and the temp went to normal and the truck drove fine. 20 miles later it happens again. I pull over, turn the truck off, turn it back on and back to normal. This happened about 15 times between Newburry Springs and Needles. I figured it was a bad temp sending unit so I tried to disconnect it but the problem persisted. I ended up parking in my buddy's river house driveway in Needles and sleeping in the back seat. It was 2am by then and I was tired.
Originally Posted by 2manymustangs
The next morning I fire the truck up, grab my boat out of storage and and head to Havasu. All is good. Later that day I'm driving to Interstate Batteries from the Islander and it happens again. So I stop at Orielly's and pick up a new sending unit, plug it in and boom, it happens again. So I called Ford in town and they said they couldn't touch it til Monday. I then called Tri-Tech Auto and they said to bring her in. The guys there were awesome BTW! I told them I was en-route to get batteries and they had Interstate deliver to their shop! .....So they plug it in and its showing a code for the cylinder head temp sending unit ( I didn't know one existed). So they replace it, clear the code and it seems fine. We go to back out of the garage for a test ride and boom. Temp gauge pegs and truck goes into limp mode. Plug it back in and we get a misfire code. #6 misfired 86 times and #10 showed only one. So they replace the coil on #6, clear the codes and the truck drove great all weekend! Last night I'm headed north on the 95 (just passing the airport) and it happens again! So I unplugged the head temp sending unit and made it all the way home with out going into limp mode and the temp gauge pegging hot.
I have no clue what the hell to do next. Anyone know a good Ford Tech around OC?Last edited by niceguyeddie; 03-17-2014 at 02:48 PM.
-
03-17-2014, 03:03 PM #4Senior Member
- Join Date
- Oct 2012
- Posts
- 19,130
If its just sensor hell you're lucky.
Not sure if you're on The Diesel Stop, but I'm sure they know who the good ones are.
Sensors are a bitch. But if there's nothing mechanically wrong, you're in luck.
-
03-17-2014, 03:15 PM #5Senior Member
- Join Date
- Dec 2013
- Location
- SE Iowa
- Posts
- 279
If they replaced the sensor, it could easily be a shorted wire. Take a VOM and check the wires to the head temp sensor.
Originally Posted by ogshotgun
-
03-17-2014, 03:36 PM #6Already miss the 310/562
- Join Date
- Sep 2013
- Location
- 314 ish....
- Posts
- 6,050
I would invest in a code scanner OR better yet, the OBD tool (plugs in service port)/software that you can monitor real time with your smartphone... Originally Posted by niceguyeddie
Was there any actual sign of the truck really getting hot OR do you suspect electronics/sensors/wiring?
I would think that there would be codes for o2 sensors if there was an injector issue and the misfire issues if it was a really bad misfire... Just a guess...
Not much you can do these days without a good scan tool...
Hi, Bruce. Here are some links for Torque Pro. http://reviews.cnet.com/8301-13746_7...p-for-android/ http://torque-bhp.com/wiki/Main_Page http://torque-bhp.com/obdforum/obd2/...iewforum/f/1.0 http://www.obdii.com/ Have fun.
Last edited by 2manymustangs; 03-17-2014 at 03:44 PM.
-In a Republic, the sovereignty resides with the people themselves. In a Republic, the government is a servant of the people, and obliged to its owner, We the People..
"Remember, democracy never lasts long. It soon wastes, exhausts, and murders itself. There never was a democracy yet that did not commit suicide." John Adams
-
03-17-2014, 03:57 PM #7GRADSGuest
Welcome to the club! Misery loves company.
-
03-17-2014, 04:09 PM #8Racer
- Join Date
- Oct 2012
- Posts
- 704
If it's a 6.0 it might have a blown head gasket. Check the water level in the radiator, I had a 07 that blew the head gasket and it did the same thing to me, coolant goes out the exhaust which reads a misfire in the cylnders. Hopefully thats not the case for you
-
03-17-2014, 04:45 PM #9Senior Member
- Join Date
- Oct 2012
- Location
- Costa Mesa, CA
- Posts
- 1,483
I hope it's just electrical. Originally Posted by Hotboat
I posted there earlier today.
Good idea! Originally Posted by SnoC653
I'll look into it a scan tool. I had one for my Chevy. Originally Posted by 2manymustangs
It didn't seem to be getting hot and when Tri-Tec monitored it with their computer it was showing normal temps.
lol Originally Posted by GRADS
Welcome to the club! Misery loves company.
It's a V10. I didn't buy a 6.0 because I didn't want problems. Go figure! Originally Posted by K-034
-
03-17-2014, 04:53 PM #10Already miss the 310/562
- Join Date
- Sep 2013
- Location
- 314 ish....
- Posts
- 6,050
Hang in there, your just getting all of the bugs worked out of her...
-In a Republic, the sovereignty resides with the people themselves. In a Republic, the government is a servant of the people, and obliged to its owner, We the People..
"Remember, democracy never lasts long. It soon wastes, exhausts, and murders itself. There never was a democracy yet that did not commit suicide." John Adams
Reply With Quote
Bookmarks