Results 1 to 5 of 5

Thread: new to forum

Hybrid View

  1. #1
    Junior Member
    Join Date
    May 2018
    Location
    antioch ca.
    Posts
    3

    blower pulley problem

    I hope iam posting in the right place.
    I have a question,i need help with.so I just got a drag hydro I put my bbc gen6 454 in it I have a 671 bds blower I just installed.my engine has the harmonic balancer on it and my bottom pully wont bolt on theres only 3 screw holes on the balancer the pully is 56 tooth and has 6 bolt holes what do I need to do .any help would be great tnx
    Last edited by coldhorce; 05-09-2018 at 01:21 AM.

  2. #2
    Welcome to www.hotboat.com

    Feel free to post anywhere you’d like.

    There are a few people here I’m sure who can help. I’ll see if i can rattle them in to a response.


    Sent from my iPhone using Tapatalk

  3. #3
    Welcome

    You don't need to run a harmonic balancer with a blower The belt will take care of the engine harmonics.
    You need to get a Blower crank hub with a degree wheel. It has the six 3/8-24 holes to bolt up the blower pulley

  4. #4
    Also I just remembered Your Balancer will have one 3/16 keyway The blower hub will have two 1/4" Keyway's
    The crank needs to be milled for the two 1/4 keyways. You can buy a 1/4-3/16 step key stock. I wouldn't recommend it
    Especially if you race it or run a high boost, I will snap the key off.
    You might get away with it running low boost with a small 671 blower, with red loctite and tighten the shit out of a ARP crank bolt.
    The first time the blower backfires It will probably snap the key off.

  5. #5
    Junior Member
    Join Date
    May 2018
    Location
    antioch ca.
    Posts
    3
    great thankyou for the help

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •