New to the forum

[steves86ta]

I re-did the Bilge again. This time i am much happier with how it came out.





I also spent some time with the buffer and polished most of the rail kit. I did the two angle sections that the engine will sit on.

And one of the two motor mounts. Going to finish this up shortly

Rough sanded with the DA and 120 grit to get all the scratches/ cutting marks off, What I dont have pictures of is the sanding after this, the 220, 320, 400, 600 wet, 800 wet, 1000 wet stages. I cheated and used a palm 1/4 sheet sander. Even for the Wet stages


Hard to see in this pic, but they came out pretty damn close to mirror finish


And one of the two motor plates