I decided to use this kit from Jeg's to mount the regulator. It came with hard lines, regulator mount and the fitting needed for regulator and bowl. It did not hav the 90* fitting on the "IN" side of the reg.

http://www.jegs.com/i/JEGS+Performan...15081/10002/-1


I like the bowl fittings that came with the kit. Unlike the stock fittings that take a 1" wrench, these have a smaller hex on them so you can actually get a socket or wrench on them to tighten them into the bowl.



I clearanced the bracket a little to clear the back line. It was touching slightly. It probably would have been fine but I didn't want to take a chance on rubbing a hole in the line.



Next winter I will pull it back off and get the bracket powder coated blue to match the throttle bracket. Summer in here and I don't want to lose another week waiting on powder at this point.






Still need to clean up the carb and bowls. I will try to get the intake polished back up tomorrow and figure out where to mount the fuel filter. Then the motor should be ready to go back in.