Lets see if we can start a thread about boats

**Paul65K** · 02-01-2014, 04:53 AM

Originally Posted by ogshotgun

lets try again its a thread about boats .. not a picture contest ... lets talk about boats and boats only so iask what do you have ?

OK then........I agree I wish it was boating season too...............Thanks for the thread.....I for one really appreciate all your boating content

**ogshotgun** · 02-01-2014, 11:10 PM

Originally Posted by Paul65K

OK then........I agree I wish it was boating season too...............Thanks for the thread.....I for one really appreciate all your boating content

thanks buddy a actual boater in this see of whatever lol

**Sharp shooter** · 02-01-2014, 10:51 AM

Originally Posted by 2manymustangs

I still have to build the AN/braided lines,

You know how to "build" braided lines? lol

Please post vid of you doing that. Leave out connecting fittings since we all know what that entails.

I would suggest spraying the boat white...lol

**gn7** · 02-01-2014, 11:14 AM

Originally Posted by Sharp shooter

You know how to "build" braided lines? lol

Please post vid of you doing that. Leave out connecting fittings since we all know what that entails.

I would suggest spraying the boat white...lol

Jerry, I take it you haven't seen the half dozen braiding machines 2MM has.

**Sharp shooter** · 02-01-2014, 03:15 PM

Originally Posted by gn7

Jerry, I take it you haven't seen the half dozen braiding machines 2MM has.

He probably builds the machine first.

**wannabe** · 02-01-2014, 03:25 PM

Hey, I have a boat.

**gn7** · 02-01-2014, 04:34 PM

Originally Posted by 2manymustangs

YOu or someone "built" a new set of plates for you HONCHO right? In so doing did you melt the aluminum, pour it, roll the ingot into plate stock BEFORE you saw cut/drilled/Csink'd the holes?

YOu are prolly aware that braided stainless likes are a TAD more involved than just spooling off some Gates 5/8" rubber heater hose, pushing them onto the barbed fittings and tightening the hose clamps... Right???
Do you "BUILD" brake lines? or do you just cut them from bulk and throw them on the car, tighten them down???

OK 2MM. lets not try to make it sound like you are assembling a blown SOHC here. Its some hose and a couple ends. Not exactly rocket science. Getting the money out of your wallet is the hardest part of plumbing a boat.

**2manymustangs** · 02-01-2014, 04:57 PM

Tutorial for Bob....

**gn7** · 02-01-2014, 05:13 PM

I spent the better part of 60 years perfecting this, and you think I'm interested in changing? Take another hit off the pipe Bruce.
if I was looking for friends, I'd have you "like me" on a Facebook page.