So.... here's what I did to the boat, when I first got the boat... I put a straight edge on the bottom to see where neutral was...with both drives at neutral... one gauge read 1.0 and the other read 2.5, so I adjusted the gauges to read 2.0 on both sides....with the drives tucked, one side read 1.5 and the other went to 0. so now a new problem.... one drive went lower than the other... with a lot of head scratchin... and looking at the situation....I finally found the problem...some one... not to mention names... put blocks on the drives that go to bravo 3's... and on one side they turned the blocks to where the drive wouldn't go all the way down as far as the other.... the idea behind the blocks id because of the transom lift on the bravo 3, and it will cause bow steer...so took the blocks out..now the boat gets on plane effortless... and it cruises nice...but ... top end it still was a hand full...