Quote Originally Posted by gn7 View Post
You know, I try to help you where ever I can, and if I remember correctly, I was the one that guided you Marine Machine, but sometimes you are simply way too fucking stupid to bother with.
i appreciate your help, i was making a point in the beginning both you and kevin were all about the machine and the surface speed to tip being constant , than in the end you say it doesn't fn matter at all.. make up your mind..does the machine make any difference or not ? a old ww1 lathe has about 6 speeds and maybe two feed speeds, the reason why they break at least 10 cutting tools a day and trash 50% of the parts, this is all after BOB has passed away, and i found Marine machine on my own gave Kevin the web site to make sure there up to the standards needed and he agreed,

marine machine vs glenwood

is like a rock vs a bazooka

also iam not fucking STUPID , stupid people just listen to all the BS and never ask a question. intelligent people ask questions to gain knowledge.. i ask a lot of questions.