Tiki bar project

[djunkie]

This started out as building something to cover the ugly pool equipment. Needless to say it snowballed into something different. Started today with just framing and making the top

[djunkie]

]The bar is getting wrapped in 1" bamboo. The bar top is gonna be out of resin. I'm laying out some weaved Palm leaves and doing a resin pour over the top. Should be interesting as I've never done it. Then it'll have a thatch roof.

Here is where it'll be. It's on wheels too so I can move it easily.

[HB Vic]

Multi talented. Nice


Sent from my iPhone using Tapatalk

[ChumpChange]

Nice! Kill two birds with one stone.

[Eli]

Looks good and kinda tall.


Sent from my Bat Cave

[djunkie]

Looks good and kinda tall.


Sent from my Bat Cave

It is tall. I didn't think about it till after I framed it up. The bamboo roll is 4ft so that's how high I built it.

[Eli]

It is tall. I didn't think about it till after I framed it up. The bamboo roll is 4ft so that's how high I built it.

4 feet isn't too high...for normal people.


Sent from my Bat Cave

[djunkie]

Got the inlay cut and layed out on the top. Waiting on the resin to show up to pour over it. Hopefully get that done later this week so I can install the bamboo around it and build the thatch roof.

[HB Vic]

How thick will the resin top be?

[djunkie]

How thick will the resin top be?

Probably somewhere around 1/4-1/2" thick. It just depends how far the resin I bought will go. If I have enough to fill it to the top of the bordering I think I may do that so that water will run off being it'll be outside.