Who's the numbnutz?

[Cigalert]

That mounted the hatch ram next to the impeller?

Sent from my hemDROID

[WMC]

yes looking at the picture bottom left. My boat is way harder then that. I have stairs

Sent from my XT907 using Tapatalk 2

[HB Vic]

I didn't know you were mechanically inclined

[Cigalert]

yes looking at the picture bottom left. My boat is way harder then that. I have stairs

Sent from my XT907 using Tapatalk 2

Do what I did with that ram....just remove them. You have to own a sawzall.

New gauges today too.

Out with the old...

And I could give a damn if they look like toon gauges....I'm having separation anxiety since the Bennington left.


Sent from my hemDROID

[WMC]

Gauges look way better

[Cigalert]

I didn't know you were mechanically inclined

I wish I were but I can only fubar 50 year old pieces of bakery equipment....everything else is just guess work.

Gauges look way better

Even though they're not the color I ordered...I could care less....big improvement over the miami vice gauges that were there.

[Cigalert]

Really nothing like last minute....

Finished:

Oil Change/Filter
Fuel Filter
Drive Oil
Impeller
New Extinguisher Install
Trim limit/sender
New Gauges
New Head unit
Wired LCD remote
Added 6x9's to back seat
Built Boxes in rear seat base for subs
New Sub amp (The new Alpine MRX series is pretty badass for the price)
traced out wiring issue with the stern light


Just need to...

Oil the floor
Polish gel
stand off bimini mounts to clear new 6x9's
Annodes for trim rams

[hallett21]

You bringing it to havasu this weekend?

[Cigalert]

Not making the races this year cause I can't pull a race boat out without needing your excavation equipment.

Leaving either monday or tues and staying through the weekend.

[niceguyeddie]

Are you going to put a clock in the missing gauge hole? I've seen a few guys with older Halletts do that once they ditched the square gauges as that gauge (can't recall what it is) is not available. Or I've seen a boost gauge used.

Sucks you cant fit bezels on the older Halletts that came with square gauges. Joel from Rodes Way Boats made a plate and powder coated it that goes behind his gauges that looks pretty nice. Shit.. his entire boat looks pretty insane after his resto.