Would you do this? I don't think they inherently porpoise like that do they? Looked scary to me
https://vimeo.com/190393374
Sent from my iPhone using Tapatalk
Printable View
Would you do this? I don't think they inherently porpoise like that do they? Looked scary to me
https://vimeo.com/190393374
Sent from my iPhone using Tapatalk
Doesn't look like it's "trimmed" properly
I concur with 314joey, it's just not trimmed properly, especially for that new of a hull. With older sixties flatbottoms, quite a few of the hull builders molds were designed with some "rocker" to the bottom, ( like my Stevens' hulls ), I'm guessing to soften the ride at lower speeds, I really don't know exactly, I'm sure someone with the firsthand knowledge like Harlan Orrin could tell us. I DO know that on lots of early drag boat videos porpoiseing is fairly predominant, maybe even "inherent", as you put it. There's a lot involved in bottom design, shaft angle, plate design and position, engine placement, that I'm sure comes into play,...but in the case of the boat in this video my guess is that it's just trimmed too loose.
Maybe he was getting seat time? Idk but there were a couple of times if I were a passenger I'd have soiled myself [emoji51]
Sent from my iPhone using Tapatalk
First guess would be operator input error, like noted above. Second would be a setup issue where the boat is fighting itself as it did seem to get worse as the clip ran.