Took the hallett to mead yesterday....fun day...

[2FORCEFULL]

So when I went through the stop to get in lake mead, the ladys says.. the water is up a little...so I said why is the lake soo low... she says, because the people in Henderson drank all the water...LMFAO:secret::secret::yikes::realitycheck: :realitycheck::realitycheck:


...65758657596576065761657626576365764657656576665 7676576865769657706577165772

[jordy]

Well???

[2manymustangs]

Well???


^^^ what he said... :D

[Ziggy]

Can't remember? :)

[2manymustangs]

2FF, how did the tab modifications work?

[ChumpChange]

Goooooood times!

[2FORCEFULL]

2FF, how did the tab modifications work?

ok,... took the hallett out that day.... the drive mod worked awesome on hole shot...right on plane ..you could hammer the sticks...or just roll it over on plane...same with mid range... you could really feel the 800 HP... but... going across the lake you had to hit rollers straight across especially on the upper speed range..if you went with the rollers, like following a roll bar boat, it would start rocking back and forth(side to side).... in fact, once it started you al most had to stop to get it to quit...kida like what happened in that video were that boat slammed every one on the boat side too side..sooo.. not good..it has always done that at high speed since it got it so you really had to drive the boat and not hve it trimmed out too much...

[2manymustangs]

:O

Say, do you know John Cogan at Concept Marine? I was visiting with him this past weekend at the races, he may be able to shed some light on your situation AND be familiar with the set up... I mentioned this to him last Friday when he was describing a similar situation on a customers boat...

[2FORCEFULL]

:O

Say, do you know John Cogan at Concept Marine? I was visiting with him this past weekend at the races, he may be able to shed some light on your situation AND be familiar with the set up... I mentioned this to him last Friday when he was describing a similar situation on a customers boat...

don't know him, but would love to sit and talk with him some day

[2FORCEFULL]

see my other thread...got it fixed...